zig-pico - RP2040/Pico SDK for Zig

This framework is for writing zig applications for the Pico microcontroller (RP2040). It is far from finished but can be a great starting point for your own projects. The project is in active development so anyting can change still. Any help would also be appreciated.

Right now it only runs from RAM, no QSPI flash support (boot-stage2) has been implemented yet.

Usage

Currently you can build your own application by using a build.zig file like~

const std = @import("std");
const pico = @import("libs/zig-pico/build.zig");

pub fn build(b: *std.build.Builder) !void {
    const mode = b.standardReleaseOptions();

    const pico_exe = pico.PicoExe.init(b, "myproject", "src/main.zig");
    const exe = pico_exe.exe;
    exe.setBuildMode(mode);
    exe.install();
}

For flashing you have to convert the elf file to a uf2 file manually (with the uf2 tool from the pico-sdk repo) and copy it to the pico mass storage drive. You could also use the picoboot tool for flashing.

Currently I mostly use a gdb session with the swd interface for flashing.

In the future this will be done with the zig build system itself.

Progress

Systems and Peripherals

Following are systems and peripherals taken from the datasheet.

SIO
Spinlocks
Integer dividers
Interpolators
FIFOs
SysTick Timer
MPU
NVIC
DMA
Core Supply Regulator
Power Control
Chip-Level Reset
Power-On State Machine
Subsystem Resets
Clocks
XOSC
ROSC
PLL ❕
GPIO ❕
Manual read and writes
Interrupts
PIO
USB
UART
I2C
SPI
PWM
Timer
RTC
ADC and Temperatue Sensor
SSI

Peripherals marked with ❕ are working, but could use some improvements.

General TODOs

Some general TODOs. There are more TODOs sprinkled throughout the code.

Figure out how to use the set of functions provided in the Bootrom. (float and double operations, memory operations, and more).
Find a way to determine at compile time which modules are used, and add initialization code for these modules to the reset sequence.
Implement error handler in crt0.zig
Add a boot-stage2 bootloader.
Add on demand compilation (and caching) for the picoboot, pioasm and uf2 tools in the pico-sdk.

Notes

• All peripherals are put in 'reset' state after a hard reset. You cannot write to their registers while in the reset state. First set the 'RESETS' register to enable the peripherals you need.